 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MIC-3321 NEW 3U CompactPCI Pentium M 2.0G High-performance Controller Features Built-in Intel(R) Pentium(R) M 760 2.0G processor with 2 MB L2 Cache Mobile Intel 915GM express chipset Supports up to 1GB DDR2 533/400 SDRAM soldered on board Extended operating temp: -25 ~ 70 C (Optional: MIC-3321C only) Dual Giga LAN on PCI-Express High-performance Intel Graphics Media Accelerator 900 VGA display Onboard CompactFlash(R) disk socket Onboard 2.5" HDD support Rear I/O signal support for easy wiring Introduction The MIC-3321 3U is a CompactPCI system controller board that combines the performance of Intel's Mobile Pentium M 760 2.0GHz processor with the high integration of the 915GM chipset and the I/O Controller Hub ICH6. The low power of the Intel Mobile Celeron(R) M makes it possible to work with high extended temperature ranges. The directed soldered CPU and memory provide less weight and a higher shock/vibration resistance than socket devices. MIC-3321 is a powerful 3U CompactPCI Controller that fulfills your requirements in mission critical applications, such as military defense, transportation, traffic control, test and measurement (T&M) as well as critical data acquisition & control applications. Specifications MIC-3321: Intel Pentium M 760 2.0 GHz with 2 MB L2 cache MIC-3321C: Intel Celeron M Ultra Low Voltage 373 1.0 GHz with 512 KB L2 cache Intel 915 GM (GMCH) + Intel 82801FBM (ICH6M) Award 4 MB Flash 533 MHz (Intel Pentium M 760 2.0 GHz CPU) 400 MHz (Intel Celeron M Ultra Low Voltage 373 1.0 GHz CPU) PCI-to-PCI Bridge: PERICOM PI7C8150 PCI Bus Memory Graphics 7 x 32bit/33MHz CompactPCI bus Master interface 3.3 V/5 V VIO adjustable Directed Soldered 512 MB DDR2 SDRAM Controller: Intel Graphics Media Accelerator 900 VRAM: DVMT3.0 128MB Resolution: Up to 2048 x 1536 with 32-bit color at 75 Hz Interface: 10/100/1000Base-TX Gigabit Ethernet Ethernet Controller: 2 x Intel 82573E/L PCI Express Gigabit Ethernet Controller Connector: 2 x RJ-45 Supports Pre-boot Execution Environment (PXE) USB PS/2 Watchdog Timer Hot Swap P-IDE Interface: RS-232 Controller: 2 x 16C550 Compatible Data Bits: 5, 6, 7, 8 Stop Bits: 1, 1.5, 2 Serial Parity: None, Even, Odd Speed (bps): 50 ~ 115.2K Data Signal: TxD, RxD, RTS, CTS, DTR, DSR, DCD, RI, GND Connector: 2 x DB9 male Two as front I/O, one as rear I/O One channel P-IDE Supports PIO mode 4 (16.67MB/s data transfer rate) and ATA 33/66/100 (33/66/100MB/s data transfer rate) 1 x CompactFlash Socket Type II 1 x 44-pin 2.5" HDD connector SATA interface with data transfer rate up to 150MB/s 1 x External SATA connector 4 x USB 2.0 channels up to 480Mbps, 2 as front I/O, 2 as rear I/O PS/2 for keyboard and mouse legacy support 0 ~ 64s, 0.25s step, generate reset signal Support for all signals to allow peripheral boards to be hot swapped. The individual clocks for each slot and access to the backplane ENUM# signal comply with the PICMG 2.1 Hot Swap specification. (PCI to PCI bridge GPIO3) CPU Chipset BIOS Front Side Bus Bus SATA CompactPCI Systems MIC-3321 1 x VGA-CRT 15-pin D-SUB connector Ethernet: 1 x RJ-45 connector with integrated LEDs USB: 2 x 4-pin connectors Reset: Reset button, guarded Front Panel Functions 8HP Board (Additional to 4HP) LED: Power, HDD COM1: 1 x DB9 RS-232 connector COM3: 1 x DB9 RS-232 connector PS/2: 1 x PS/2 connector for keyboard and mouse Ethernet: 1 x RJ-45 connector with integrated LEDs 2 x USB 2.0 channels 2 x Gigabit Ethernet channels with LED (shared with front I/O) Rear I/O via J2 1 x COM port 1 x VGA-CRT channel (shared with front I/O) 1 x PS/2 keyboard/mouse channel (shared with front I/O) Compliancy PICMG 2.0 Rev. 3.0 compatible CompactPCI Hot Swap Specification PICMG 2.1 R2.0 0 ~ 50 C (Pentium M 2.0G CPU) Environment Operating Temperature Storage Temperature Dimensions (W x H) Weight Rear Transition Board P/N Width 0 ~ 50 C (Celeron M 1.0G CPU) -25 ~ 70 C (Optional: Celeron M 1.0G CPU only) -40 ~ 80 C 160 x 100 mm (3U) 0.6 Kg MIC-3521 8HP Front View of MIC-3321 MIC-3321 MIC-3521 4HP Board Physical Ordering Information MIC-3321 MIC-3321C MIC-3521 Pentium M 2.0 GHz, 2MByte L2 cache, 512 MByte soldered DDR2 SDRAM, 8 HP width Celeron M 1.0 GHz, 512KByte L2 cache, 512 MByte soldered DDR2 SDRAM, 8 HP width Rear I/O Transition Board for MIC-3321 series Online Download www.advantech.com/products |
Price & Availability of MIC-3321
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |